F106 Axle Housing
IMS F106 axle housings have been designed in-house with truck pulling in mind. To ensure unparalleled durability and reliability, each housing is constructed with a robust 3/8” thick faceplate and sturdy 3/16” housing A36 steel. The axle tubes are welded to the faceplate, housing, and internal gusseting, forming a cohesive structure that delivers exceptional strength under extreme conditions. After the housings are welded, the faceplates undergo precise machining to achieve a perfectly flat surface.
Housings come fully welded with tubes that can be cut to length. We can also add spindles, billet hubs, billet third member, spool and axles shafts to make a complete axle for your application.
Hubs, spools, billet third - call for quote
This item is proudly designed, engineered, and manufactured in house at IMS.
Additional Info
Building an axle using 2005+ Super Duty outer C’s and want brand-new C’s to start with? These are the solution. Cast and machined in the USA, they’re built for durability.
For builds that will see extreme terrain, we added 1/2" to the inner side for increased engagement and incorporated webbing to tie the upper and lower portions of the knuckle into the added material. We’ve made these available in 3.5” to 4” OD tube so they are ready to install.
These tube seals are designed and made in-house. The outer piece permanently mounts in the tube and allows the inner aluminum housing and seal setup to be removed from inside the housing. We use Seals-It seals with all of our tube seals.
These IMS Unit Bearing Cups are specifically designed to seamlessly integrate 05+ Super duty unit bearings into your straight axle construction. By incorporating these cups and unit bearings, you can bypass the conventional spindle and hub arrangements, opening the door for the utilization of 40 spline axle shafts in your setup.
Cups come in 3.5” and 4.0” bores. Additional sizes can be made upon request.